Standing seam and metal panel roofing, roof repair and full replacement in Gates Mills. We show up when we say we will, and we clean up before we go.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Gates Mills.
Reflective coatings keep a metal roof cooler in summer and seal up the small stuff before it turns into a leak.
Careful footwork, matched materials, and flashing done the way it was done when the roof went on.
Water runs along decking and rafters before it ever drips, so the stain is rarely under the hole. We trace the leak back to where it really starts and fix that.
Hard wind lifts shingles and works panel fasteners loose along the edges, which is exactly where the next storm gets underneath. We refasten, replace and reseal.
When a roof is genuinely finished we replace it, and we say so plainly rather than dressing it up. Metal and shingle priced side by side so you can compare real numbers.
We match the guard to your trees and your gutter profile, and make sure water can still get in where it is supposed to.
We repair what the storm actually broke. If that is one slope, we do one slope, and we will not pad an estimate to make a claim look bigger.
We still shingle plenty of roofs. Cracked, curled and blown off shingles get replaced, and the valleys and flashing get reworked while we are up there.
This is the work our name is attached to. Two decades of tin roofs on houses, churches, barns and additions, installed by crews who cut the trim on site instead of forcing something that almost fits.
Lifted panels, missing shingles, flashing that has given up where the chimney comes through. We find what is actually wrong, fix that, and leave the rest of your roof alone.
A twenty year old panel roof usually needs fasteners and sealant, not replacement. We refasten with new washers and get you another long stretch out of it.
Steam and hand work, never a hammer and chisel on your roof. Then we check the eaves for the damage the ice already did.
A careful walk over the whole roof — panels, shingles, valleys, flashing, fasteners — plus the attic side when there is a way in. You get photos and a straight answer.
Underlayment, ice and water shield in the valleys and along the eaves, sealed penetrations, and proper closures at the ridge.
Storm damage does not wait for business hours. We get the opening closed, photograph it for your insurance, and put the real fix on the schedule.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
Squirrels, wasps and water all treat a soft soffit as a front door. We close it up properly instead of patching over it.
Repair or replace, we handle both, and we work from what the roof actually needs rather than from what an adjuster might approve.
Porch roofs, additions and low slope sections that hold water instead of shedding it. We rework the flashing, seal the seams, and get water moving again.
We work around your hours, weekends included when that is what it takes to keep your doors open while the roof goes on.
Here is what working with us looks like in Gates Mills: you call, somebody comes out and measures, and you get a written estimate with the panel or the shingle spelled out on it. If you say go, we schedule you and we show up on that day.
The crew tarps the beds, keeps the yard picked up as they go, and runs a magnet over the drive before pulling out. Small things, but they are the ones Gates Mills homeowners still mention a year later.
Here is what Gates Mills homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Beds get covered, tear off gets hauled as we go, and a magnet goes over the drive before we pull out. Your yard should look like we were never there.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
A few backed out screws or a whole roof off a church — we take both. No job is too small to get the same crew and the same care.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
The questions that come up on just about every estimate we write.
A typical Gates Mills shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Much less than people expect. Over solid decking with underlayment under it, a Gates Mills metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
Sometimes. If the decking is sound and there is only one layer of shingles, a Gates Mills metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
That is most of what leak work is. Water runs along decking and rafters before it ever drips, so the stain on your Gates Mills ceiling is rarely under the actual hole. We work back to the real entry point, fix that, and check the rest of the roof while we are up there.
Most Gates Mills metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
Any dry stretch works. We roof in Gates Mills year round, though we schedule shingle work for when it is warm enough for the strips to seal properly, and we watch the forecast so your house is never left open overnight.
Real feedback from homeowners whose roofs we have worked on.
"They replaced the soffit and fascia the squirrels had chewed through and closed everything back up tight. No more scratching in the attic at night."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Wind peeled up the edge of our roof and they came out that same evening to cover it so the rain would not get in. Permanent repair the following week."
Roofing Brothers also serves these towns near Gates Mills.